Wegener UNITY4000 Manual de usuario descargar pdf (Pagina 10)

ee--mmaaiill::

vvooiiccee::

360.854.9559

ffaaxx::

360.854.9479

USC-16/SG Installation and Operation Manual

PROGRAMMING

COMPUTER BURST MODE COMMANDS

Burst mode allows a computer or ASCII terminal to control the unit. This section

defines all burst mode commands. Each burst mode commands starts with an aster-

isk (“*”). Next is a single decimal digit that corresponds to the unit (ID) address 1-

7 (¯ NOTE: Not required when the ID is 0). Following that are one or more ASCII

characters specifying the command. A carriage-return is required to terminate the

command. Unsuccessful commands are responded to with “ERROR”. The syntax

of each command is given below. The syntax shows the command exactly as it

should be sent, except that lower case characters represent values that should be sub-

stituted:

GLOSSARY OF COMMAND NOTATION

Character String Meaning Allowable Values

U Unit ID 1 – 7,

NOTE: Not required

with ID = 0

cc Memory Number 01-16

Xxxxx String

COMMANDS

*uU<cr> Send units model and version number

*uPxxxxxxxxxxxxxxxx… (Pass-through) Send this string to the receiver

*ucc<cr> USC-16/SG Memory location

Example:

*01<cr> Commands the USC-16/SG with a ID of 0 to send the

ASCII string stored in Location 01 to the Receiver

*101<cr> Commands the USC-16/SG with a ID of 1 to send the

ASCII string stored in Location 01 to the Receiver

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Wegener UNITY4000 Manual de usuario Pagina 10