Wegener Unity 4650 Manual de usuario descargar pdf (Pagina 68)

Unity 4650 User’s Manual

800034-01 Rev. A 68 wegener.com

SETPEDEST

xxx

xxx: “E” for enable or “D” for disable.

Enables or disables the “pedestal” setup, the addition of +7.5 IRE to the lumi-

nance level of active NTSC video. A Local Control Command (available from

the terminal regardless of "Local Control Enable/Disable" commands from the

network).

SETPIN

value

value: Decimal representation of PIN key, between 0 and 16777215.

Command sets the PIN scrambling key number.

SETTIMEOUT

source time

time: Time-out value in seconds or HHHH:MM:SS format. Minimum value is

1, and maximum value 35999999 (9999:59:59 hms) for all others.

Command sets Automated Recovery timeout specified by source to the value

specified by time.

SETUID

[id]

id: Unit ID number between 00 and 99 inclusive.

Command for assigning the unit ID number for gaining "talker" access on a

shared serial bus. The factory default setting for id is '00', which also disables

terminal daisy-chain capability. If the parameter is omitted, then this command

returns the current unit ID setting. Command is only applicable to products that

feature serial "daisy-chain".

source: 1 - Not used. (In legacy IRDs, this was Fade timeout.)

2 - Services Recovery Timeout. (In legacy IRDs, this

was Installation timeout.)

3 - Network Recovery Timeout. (In legacy IRDs, this

was No COMPEL



timeout.

4 - Recovery Iteration Time. (In legacy IRDs, this was

Header Seek timeout.)

5 - Local Control Re-enable Timeout. (In legacy IRDs

this was Local (Control) Recovery timeout.)

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 91 92

Sin comentarios

Wegener Unity 4650 Manual de usuario Pagina 68