Wegener DVR395 Guía de instalación

Installation Guide Model DVR395/DVR396 DIGITAL VIDEO RECEIVER Data, drawings, and other material contained herein are propriet

Page 10 DVR395/DVR396-002 Page 10 of 30 required if the room is cool (<75°F). For higher rack mounting densities, forced-air rack ventilation i

Page 11 Page 11 of 30 DVR395/DVR396-002 1.4 REAR PANEL CONNECTIONS The DVR395 rear panel connections are shown and described in Figure 2 (Page13

Page 12 DVR395/DVR396-002 Page 12 of 30 installations, but especially in multi-service environments, should use high-quality shielded cables, with

Page 13 Page 13 of 30 DVR395/DVR396-002 Figure 2. DVR395 Rear Panel Figure 3. DVR396 Rear Panel MODULE 1RS232CONTACT RATING 0.1A @ 30VDCAUDI

Page 14 DVR395/DVR396-002 Page 14 of 30 1.5 SECURITY LABELS The DVR395 incorporates security labels. There are no user serviceable components withi

Page 15 Page 15 of 30 DVR395/DVR396-002 VIDEO CONNECTIONS Composite: connect the composite video output to the desired unit using a standard phon

Page 16 DVR395/DVR396-002 Page 16 of 30 1.6 TECHNICAL SUPPORT In the event the unit fails to perform as described, contact Wegener Communications

Page 17 Page 17 of 30 DVR395/DVR396-002 SECTION 2 POWER ON PROCEDURES 2.1 GENERAL This section provides information and procedures

Page 18 DVR395/DVR396-002 Page 18 of 30 Figure 4. DVR395 Front Panel Figure 5. DVR396 Front Panel MODEL DVR395S/NSTATUS SELECT ENTERMPEG-2 IRD

Page 19 Page 19 of 30 DVR395/DVR396-002 Table 5. Front Panel Controls and Indicator Item Description IRD Status A Red/Green/Amber LED used to s

Page 2 DVR395/DVR396-002 Page 2 of 30 This Page Intentionally Left Blank

Page 20 DVR395/DVR396-002 Page 20 of 30 Table 6. LED Indications Mode Condition Status LED Power Up IRD is in process of powering up RED/GREEN

Page 21 Page 21 of 30 DVR395/DVR396-002 The following definitions apply to Table 6: Blink - LED is OFF for 1 second, and then blinks on count t

Page 22 DVR395/DVR396-002 Page 22 of 30 This Page Intentionally Left Blank

Page 23 Page 23 of 30 DVR395/DVR396-002 SECTION 3 SETUP 3.1 GENERAL This section provides procedures for initial setup of the unit.

Page 24 DVR395/DVR396-002 Page 24 of 30 3.3 CUSTOMIZING SETTINGS FOR YOUR SYSTEM You can customize the settings of the DVR395 to fit your system u

Page 25 Page 25 of 30 DVR395/DVR396-002 For Carrier Status: • From the Main Menu, select “Carrier Status.” • Press <ENTER> to display the

Page 26 DVR395/DVR396-002 Page 26 of 30 For Software Version: This is a read-only screen showing the versions of the various software packages. •

Page 27 Page 27 of 30 DVR395/DVR396-002 APPENDIX A RMA REQUEST FORM Not every system or location will use the RMA Request Form show

Page 28 DVR395/DVR396-002 Page 28 of 30 [email protected] RMA REQUEST FORM Fax (770) 232-0621 Company Name: Bill-To Address:

Page 29 Page 29 of 30 DVR395/DVR396-002 RECORD OF REVISIONS Date of Change Rev. Level Page No. Description of Change 7/19/97 A Initial Release

Page 3 Page 3 of 30 DVR395/DVR396-002 CAUTIONRISK OF ELECTRICSHOCKDO NOT OPENCAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,DO NOT REMOVE COVER

Page 30 DVR395/DVR396-002 Page 30 of 30 SERVICE RETURN ADDRESS Service Department RMA# ________ Wegener Communications, Inc. 359 Curie Drive Alphar

Page 4 DVR395/DVR396-002 Page 4 of 30 This Page Intentionally Left Blank

Page 5 Page 5 of 30 DVR395/DVR396-002 ABOUT THIS MANUAL This manual was composed in Microsoft Word 97, and is configured to be used most easily a

Page 6 DVR395/DVR396-002 Page 6 of 30 This Page Intentionally Left Blank

Page 7 Page 7 of 30 DVR395/DVR396-002 TABLE OF CONTENTS ABOUT THIS MANUAL...

Page 8 DVR395/DVR396-002 Page 8 of 30 LIST OF ILLUSTRATIONS Figure 1. Ferrite Bead Installation For DVR396 ....

Page 9 Page 9 of 30 DVR395/DVR396-002 SECTION 1 GENERAL INFORMATION 1.1 INTRODUCTION This section contains instructions for connecti